Thursday, 7 March 2013

Grade Six students heading to Ottawa U



by Zuha S.






You will never believe this!

There is an engineering contest from OttawaU and only sixty students can participate. In grade 6 there are 25 students. On March 6 2013 we got admitted into the contest. After the March break, grade 6 is going  to go to OttawaU and we will learn a lot about engineering. There will also be many activities we can do. We are very excited.

1 comment:

  1. Plastic injection molding has made a ton of advancements over time, and it is a fantastic method of producing parts at large scale with minimal labor necessities. Injection Moldingis the process of pushing or injecting molten toilet flusher arm plastic right into a mold cavity. Plastic resin is fed right into a heated barrel, combined, and injected right into a device, the place it cools and hardens to the configuration of the mold cavity. Lomont’s molding process is good for high or low production runs and can handle the challenges of complex geometries.

    ReplyDelete